When replacing the sprocket, check and adjust the offset. The sprocket should not swing or skew when installed on the shaft. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the deviation can be 1 mm; when the center distance of the sprocket is more than 0.5 meters, the deviation can be 2 mm. However, there must be no friction on the side surfaces of the sprocket teeth. If the two-wheel sprocket is mounted on the shaft, there should be no swing or skew. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is less than 0.5 meters, the deviation can be 1 mm; when the center distance of the sprocket is more than 0.5 meters, the deviation can be 2 mm. However, there must be no friction on the side surfaces of the sprocket teeth. If the two wheels offset too much, it will easily cause chain disconnection and accelerated wear.
