1. Use a brush to lubricate the double-pitch roller conveyor chain. If a low-speed category (υ<1m/s) is initiated, a pig hair brush should be used, and in the high-speed category (υ>5m/s), the application of nylon wool should be initiated. Brush, if it is a brush with a speed between the two can be applied. However, when the speed is extremely high (υ>10m/s), it is required to force the oil to be lubricated for heat dissipation, and the normal temperature should not be higher than 70 °C.
2, the use of drip lubrication double-pitch roller conveyor chain and chain running speed, when the speed is low, about 5 to 20 drops per minute, when the speed is high, more drops. Do not deviate too much oil droplets, do not just drop the oil in the middle of the chain, because this can not effectively lubricate the combined area of the double-pitch roller conveyor chain. The lubricant is dripped onto the inside of the pin and rolled over the side panel.
3. When the oil bath or oil pan is lubricated, the diameter of the oil pan should be sufficient to produce a rotation speed of 3.3 to 4.5 m/s. When the chain width is greater than 25mm, the oil pan should be installed on both sides of the sprocket.
4. When the oil is lubricated, the oil should be added to the inner side of the chain ring, just at the ring connection of the chain plate. The oil should be evenly distributed along the chain width to the side of the chain slack.
