Agricultural machinery gear maintenance and maintenance methods:
1. During the operation process, the soil collected on the inner wall of the machine and the mechanical parts is often removed in time, which can reduce the mechanical load and reduce the wear of the hammer claw or the knife.
2. Standard gear oil should be added to the gear box in time. The general oil level is suitable for immersing the gear in one third of the oil level. It is required that the gearbox should be cleaned and the gear oil should be replaced at the end of the operation and maintenance of the machine every year. The butter should be filled once every shift (12 hours of operation) at each place where grease needs to be filled.
3. Check the wear of hammer claws or knife throwers. When they must be replaced, they should be replaced in groups to maintain the power balance of the cutter shaft. The hammer claws of the same group should be graded by quality, and the weight difference should not be more than 25 grams. The knife can only be installed on the drum.
4. When replacing the two 53512 bearings of the roller, three M16 bolts (with a buckle length of not less than 70mm) can be used, using the technology at the rear of the bearing
