Consists of two cone rings and must be equipped with a fastening falange, usually manufactured by the customer. The number of locking screws depends on the torque to be transmitted. It is not self centering. Z1 lock requires very small axial installation dimensions. Up to 4 units can be arranged bebind each other, so allowing high torques to be transmitted. Available for shaft diameters from 6 to 600mm
Easy assembly and disassembly.
Both actions take place by locking and unlocking the clamping screws with common tools.
The use of a torque wrench is only necessary when a more precise torque is required.
Superior holding power
The action of the clamping cones creates shaft clamping torque superior to a normal keyed hub.
When the pre-set torque is exceeded locking device will slip, preventing the connected elements from being broken.
Note: Locking units are not friction couplings, so excessive slip will cause damage.
Combining the locking device design of smooth cone action with superior holding power, the hub can be clamped at any position along a shaft, eliminating the need for lock washers, spacers , stop rings, etc.
Hot Tags: Z1 type lock lock assembly, China, suppliers, manufacturers, factory, made in China